Mountain Bike Rider: Loosing my bearings

You are not logged in.
Login | New user registration

Main Index | Search | Active Topics | Who's Online | FAQ / HELP

Mountain Bike Rider Forums >> Technical (maintenance & workshop)

| Print Thread

yoon
stranger

Reged: 20/06/2009
Posts: 4

Re: Loosing my bearings
21/06/2009 00:08

Try this, Get one socket big enough for the bearing to go into on one side. put a long bolt through the whole lot, you may need a washer or two in the right place. as you tighten a nut onto the bolt it should pull the bearing out. It's better than hammering. Also try heating the whole thing with a blowtorch (not too much!) then Quench with WD40 to break the hold the corrosion has if it's corroded in.

Post Extras

Entire topic
Subject	Posted by	Posted on
Loosing my bearings	dogboy73	20/06/2009 19:57
Re: Loosing my bearings	greeneye	20/06/2009 20:02
Re: Loosing my bearings	dogboy73	20/06/2009 20:14
Re: Loosing my bearings	MTBLeague	20/06/2009 20:27
Re: Loosing my bearings	dogboy73	20/06/2009 22:07
Re: Loosing my bearings	MTBLeague	20/06/2009 22:53
Re: Loosing my bearings	yoon	21/06/2009 00:08
Re: Loosing my bearings	Rampage	21/06/2009 01:55
Re: Loosing my bearings	dogboy73	21/06/2009 03:47
Re: Loosing my bearings	dogboy73	21/06/2009 07:36
Re: Loosing my bearings	greeneye	21/06/2009 10:41
Re: Loosing my bearings	dogboy73	21/06/2009 11:56
Re: Loosing my bearings	greeneye	21/06/2009 12:00
Re: Loosing my bearings	MTBLeague	21/06/2009 12:21
Re: Loosing my bearings	dogboy73	21/06/2009 15:11
Re: Loosing my bearings	greeneye	20/06/2009 21:26

Extra information

1 registered and 45 anonymous users are browsing this forum.

Moderator: AndyWaterman, JamieD

Print Thread

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      Mark-up is enabled

Rating:
Thread views: 274

Mountain Bike Rider homepage

Generated in 0.024 seconds in which 0.001 seconds were spent on a total of 11 queries. Zlib compression disabled.